Jepson 9435 T3 Operation Instructions Manual page 10

Saw blade guides
Regularly spray the spots where the saw blade comes into contact with the saw blade
guides with lubricating oil spray. Since the vibration dampers are consumption parts,
they should be replaced when they are worn down by approx. 3 mm to a residual
value of 1 mm.
MAINTENANCE:
Replacing the carbon brushes: (Figure 8 and 9)
1. Replace the carbon a brush when they are worn down to approx. 1/4" (6 mm) or
spark formation occurs. Both brushes must be replaced at the same time.
2. Remove the worn brushes, insert the new brushes and close the cover again.
MATERIALS:
Tubes and profiles made of steel and stainless
-
steel.
The carbon brushes must be
replaced by an electrician!
10
25