Maintenance; Warranty - Dynamix SENIOR DMX User Manual

User guide Senior DMX
CARE
EN
The appliance can be cleaned using a
sponge or a slightly damp cloth.
To clean the inside of the bell, run the
appliance with the tube and its bell in clean
water for 3 seconds.
Clean the stand in clean water using
washing up liquid if necessary.
Be carreful : risk of cuts when clea-
ning the mixer attachment equip-
ped with the blade.
NEVER clean the appliance using a hose.
NEVER immerse the motor block in liquid.

MAINTENANCE

It is preferable to regularly check:
- That the power cable is in good condi-
tion (the copper wires in the cable
should not be visible).
- That the tube is watertight (by visual-
ly inspecting the seal condition after
having removed the blades).
- That the blades are sharp.
If the power cable is damaged, it must be
replaced by the manufacturer, its after-
selfs service or people of similar qualifica-
tion to avoid danger.
ELECTRIC REQUIREMENTS
The mixer of a class 2 category (double
insulation) powered by a single phase
alternating current and does not require a
"u" ground plug.
551250 G20M
The installation must be protected by a
ground fault circuit breaker and a 10 A
calibre fuse.
Use a standard 10/16 A single phased
socket.
Check that the electricity supply voltage
and the value on the mixer specifications
plate are compatible.
ELECTRICAL DIAGRAM
S1
N
L
CERTIFICATE OF CONFORMITY
CUSTOMER SERVICE AND

WARRANTY

This machine is in accordance with CE
standards and :
• Customer service and warranty:
Should your unit require service, contact
your distributor for the nearest autho-
rized service centre if you wish your
unit to be serviced by the manufacture
ship it to :
CANADA SERVICE CENTRE DYNAMIC
INTERNATIONAL LTD.
3227 boul. Pitfield
0.1 uf
10