Electrolux EIV65346X User Manual page 21

Problem
Residual heat indicator
does not come on.
Hob²Hood does not work.
Automatic Heat Up does
not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no sound when
you touch the panel sensor
fields.
The flexible induction
cooking area does not heat
up the cookware.
comes on.
comes on.
Possible cause
The zone is not hot be‐
cause it operated only for a
short time or the sensor is
damaged.
You covered the control
panel.
The zone is hot.
The highest heat setting is
set.
Power management oper‐
ates.
The cookware is too large
or you put it too near to the
controls.
The sounds are deactiva‐
ted.
The cookware is in a
wrong position on the flexi‐
ble induction cooking area.
The diameter of the bottom
of the cookware is incor‐
rect for the activated func‐
tion or function mode.
Child Safety Device or
Lock operates.
There is no cookware on
the zone.
The cookware is unsuita‐
ble.
ENGLISH
Remedy
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Remove the object from
the control panel.
Let the zone become suffi‐
ciently cool.
The highest heat setting
has the same power as the
function.
Refer to "Daily use".
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer
to "Daily use".
Place the cookware in the
correct position on the flex‐
ible induction cooking
area. The position of the
cookware depends on the
activated function or func‐
tion mode. Refer to "Flexi‐
ble induction cooking
area".
Use cookware with a diam‐
eter applicable to the acti‐
vated function or function
mode. Use cookware with
a diameter smaller than
160 mm on a single sec‐
tion of the flexible induction
cooking area. Refer to
"Flexible induction cooking
area".
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware.
Refer to "Hints and tips".
21