Table of Contents
Advertisement
1. Loosen the six (6) screws on the AirLink
Wireless Vibration Sensing Device cover.
NOTE: The screws are intentionally
retained to the cover, when loosened, to
prevent losing them.
2. Install (3) fully charged AA batteries in
the device. Be sure to orient the batteries
properly so +/- matches indicators shown
on battery case.
INSTALLING / CHANGING BATTERIES
TM
3 - ENG
3. Replace the cover making sure the
perimeter seal (O-ring) is in place, then
securely tighten the six (6) screws. Be sure
not to over-tighten screws.
4. Press & hold button 3 seconds until light
flashes blue 3 times indicating the device
is ON.
5. Press & hold button 3 seconds again until
light flashes red 3 times indicating the
device is OFF.
NOTE: If the device is ON, it will record
any movement such as walking with the
device in hand or installing the device to
the compressor so be sure to keep it off
until installed on the desired compressor
and ready to use.
6. Operating temperature range of the device
depends on AA batteries (32° F / 0° C to
104° F / 40°C).
Advertisement
Table of Contents
