Table of Contents
Advertisement
DSL-514 ADSL Router User's Guide
Home＞WAN＞Static IP Address
Choose Static IP Address if all WAN IP information is provided to you by your ISP. You will need to enter
in the VPI, VCI, IP Address, Subnet Mask, ISP Gateway Address, DNS Address and select connection
type provided to you by your ISP. Each IP address entered in the fields must be in the appropriate IP
form, which are four IP octets separated by a dot (x.x.x.x). The Router will not accept the IP address if it is
not in this format.
VPI: If instructed to change this, type in the VPI value for the initial connection.
VCI: If instructed to change this, type in the VCI value for the initial connection.
Connection Type: Change connection method and packet encapsulation technique as instructed by
your ISP. The available connection types are 1483 Router IP LLC, 1483 Router IP VC-Mux,
RFC1577-IPoA, form the pull-down menu. Default Connection Type = 1483 Router IP LLC.
Virtual Circuit: Selection Enable or Disable.
IP Address: Provided by ISP. Check with your ISP to get this information. Type in the Global IP address
for this interface.
Subnet Mask: If you are assigned Static IP addresses and Subnet mask, Type in Subnet mask for this
interface.
ISP Gateway Address: Specify the IP address that identifies the ISP server through which your Internet
connection will be routed.
Primary/Secondary DNS Address: This option is useful only when the Router is configured to act as a
DHCP Server for your LAN. Enter the Primary and Secondary DNS Server address provided by your ISP.
ATM
Service Category: UBR and CBR are supported form the ATM.
Bandwidth: Bandwidth setting takes effect only when the CBR is selected. The maximum available
bandwidth is from the upstream data rate of ADSL status page.
44
Advertisement
Table of Contents
