Advertisement
Functions
BEFORE FIRST USE
Remove and safely discard any packaging
material or promotional labels attached to your
kettle. It is recommended that before first use
to fill the kettle to the maximum level with cold
tap water, bring to the boil by selecting the
BOIL 100° button, then discard the water. Your
kettle will only operate when positioned on
the power base. The kettle will automatically
switch off when the water has reached the
selected temperature.
OPERATION OF YOUR KETTLE
1. To fill the kettle, remove it from the power
base and open lid by pressing the lid release
button. Fill with the desired amount of
water.
NOTE
Always fill the kettle between the minimum
(500ml) and maximum (1700ml) marks on the
water window. Too little water will result in the
kettle switching Off due to the safety boil dry
protection. Filling above the maximum mark
(MAX) may result in boiling water splashing
from the kettle.
2. Ensure the lid is closed and locked firmly
into place. Position the kettle securely onto
the power base. Insert the power plug into
a 230/240 power outlet and switch on. The
START/CANCEL and 100° BOIL button
surrounds will illuminate in white for one
minute.
A beep will sound for two seconds.
The START/CANCEL button surround will
automatically switch off after one minute if
not selected.
NOTE
If the START/CANCEL button is pressed
(before selecting a temperature button),
the START /CANCEL button surround will
illuminate in red and the 100º button surround
will illuminate and the kettle will start heating.
3. Select the desired setting by pressing one
of the five temperature buttons (80°, 85°,
90°, 95°, 100°). The selected button and
the START/CANCEL button surround will
illuminate in white.
NOTE
The KEEP WARM function can be
selected before, during or on completion of the
water heating cycle (refer page 9).
4. Press the START/CANCEL button and
the surround will illuminate in red, the
selected temperature button surround
will illuminate and the kettle will start
heating. Do not remove the kettle from
the power base during operation. Ensure
the kettle has switched off after the water
has boiled or the selected temperature
has been reached before removing the
kettle from the power base. If the kettle
is removed from the power base during
the KEEP WARM function the kettle will
automatically switch off.
5. When the kettle has heated the water to
the selected temperature, 3 beeps will
sound, the START/CANCEL button
surround illumination will switch off,
and the selected temperature button
surround will remain illuminated for
1 minute before switching off.
11
Advertisement
