Filter Information - ElectiQ eiQ52CANOPY User Manual

Canopy cooker hood kitchen extractor fan in silver
Table of Contents

Advertisement

CONTROL PANEL SURFACE
The inlay control panel can be cleaned using warm soapy water. Ensure the cloth is
clean and well wrung before cleaning. Use a dry soft cloth to remove any excess
moisture left after cleaning.
Using neutral detergents and avoid using harsh cleaning chemicals, strong household
detergents or products containing abrasives, as this will affect the appliance
appearance and potentially remove any printing of artwork on the control panel and
will void manufactures warrantee.
GREASE MESH FILTERS
The mesh filters can be cleaned by hand. Soak them for about 3 minutes in water with
a mild detergent then brush it gently with a soft brush. Please do not apply too much
pressure, avoid to damage it . (Leave to dry naturally out of direct sun light)
Filters should be washed separately to crockery and kitchen utensils. it is advisable
not to use rinse aid.
INSTALLING GREASE MESH FILTERS
To install filters for the following four steps.
1. Angle the filter into slots at the back of the
hood.
2. Push the button on handle of the filter.
3. Release the handle once the filter fits into a
resting position.
4. Repeat to install all filters.
CARBON FILTER-not supplied
Activated carbon filter can be used to trap odours. Normally the activated carbon
filter should be changed at three or six months according to your cooking habit. The
installation procedure of activated carbon filter is as below.
1. Put the pin of the carbon filter into the
rectangular hole of the fan (as per the arrow
A shown below)
2. Push the other side of the carbon filter
toward the fan to make it flat (as per the
arrow B shown),and then press filter into fan.
3. If you want to remove the filter, press fastener of
filter and remove it by turning anticlockwise.
NOTE:
Make sure the filter is securely locked. Otherwise,
it would loosen and cause dangerous.
When activated carbon filter attached, the
suction power will be lowered.
Replacement carbon filters can be sourced from
the supplier using the code: eiqcf150
8

Advertisement

Table of Contents
loading

Related Products for ElectiQ eiQ52CANOPY

This manual is also suitable for:

Eiq70canopy

Table of Contents