Brew Pause Feature; Charcoal Water Filter - Cuisinart EXTREME BREWTM DCC-2750 Instruction Booklet

Extreme brew dcc-2750 series 10-cup thermal programmable coffeemaker
Table of Contents

Advertisement

and fully inserted in the basket. It may
help to fold and flatten the seams of a
paper filter beforehand. Add 1 scoop of
ground coffee per cup. Adjust the
amount according to taste.
NOTE: The maximum capacity for
ground coffee is 15 scoops (15 table-
spoons) for this coffeemaker. Exceeding
this amount may cause overflow if the
coffee is too finely ground.
Replace the filter basket in the filter bas-
ket holder and press firmly on cover to
be sure it closes securely.
5. Before brewing coffee
make sure the thermal carafe is in
position on the resting plate and the top
cover is closed. plug the cord into an
electrical outlet.
6. Power unit
Turn the Function knob to BReW, press
the On/Off button, and the red indicator
light will turn on. Or, set the Auto On
function (see page 7) and the green indi-
cator will light.
7. After brewing is complete
Once the coffee has finished brewing,
the unit will immediately shut off and alert
you with five beeps. Coffee will continue
to stream from the filter for several
seconds.
note: Reservoir cover may be hot during
and directly after brewing. Wait at least 10
minutes before opening.
Brew Pause
This feature interrupts the flow of coffee
from the basket to let you pour that first
cup mid-brew. Because the flavor profile of
coffee brewed at the start of a cycle differs
from that brewed towards the end, be
aware that using this feature will weaken
the flavor strength of the finished pot.
NOTE: Removing carafe for more than 20
seconds may cause filter basket to
overflow.
Feature

CHARCOAL WATER FILTER

your coffeemaker comes with a
charcoal water filter that eliminates
chlorine, bad tastes and odors from
tap water.
Inserting the Water Filter
• Remove the filter from polybag and
soak it, fully immersed, in cold tap
water for 15 minutes.
• Lift the water filter holder out of the
water reservoir (see diagram, page 5).
• Press down on the filter compartment
and pull toward you to open.
• Place filter into the holder and snap
it closed. Be careful – improper
placement can tear the filter skin.
• Flush filter by running cold tap water
through holes in bottom of
compartment for 10 seconds.
• Allow the filter to drain completely.
• Slide the water filter holder back into
the channel in the water reservoir,
pushing it down to the base of the
unit.
nOTe: We recommend
changing the water filter
every 60 days or after
60 uses, and more
often if you have
hard water.
Replacement filters
can be purchased in
stores, by calling
Cuisinart Customer
Service, or at
www.cuisinart.
com.
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents