Advertisement
Riverside
FURNITURE
email: info@riverside-furniture.com
Step 3. Connect one End Frame to the end of the Top Frame, using the Allen Head Bolts (D), Spring
Washers (F), and Flat Washers (E). Do not fully tighten until the entire Desk has been assembled.
Step 4. Position the Back Stretcher between the two End Frames and attach the remaining End Frame using
the same Bolts and Washers as in the previous step.
Step 5. Tighten Bolts previously installed using the 5mm Allen Wrench.
Step 6. Connect the ends of the Back Stretcher using the Allen Head Bolts (H), Spring Washers (J) and Flat
Washers (I). While pulling end of Stretcher snug to the End Frame, tighten bolts using the 4mm Allen
Wrench (K).
Carefully set the Desk
upright and reinstall
Drawers back into
the Desk if necessary.
pull out
Coventry
Home Office
Assembly Instructions
pull out
If it becomes necessary to remove a drawer, follow
these steps. With the drawer fully open, the drawer
slides must be released by pushing the "trigger" located
in the slide either up or down, depending on which
slide is being released. With both triggers pushed,
gently pull the drawer until the slides release.
Carefully reinstall the drawers by aligning the channels
of the drawer slides and gently pushing the drawers
back into the cabinet.
Page 2 of 2
Made in China
There are levelers located in
the bottom of the Legs which
can be adjusted to compensate
for uneven flooring if needed.
Advertisement
