Table of Contents
Advertisement
10
Appendices
Troubleshooting
If you experience a problem with your Acer projector, refer to the following
troubleshooting guide. If the problem persists, please contact your local reseller
or service center.
Problems and Solution
#
Problem
Solution
1
The projector stops
If possible, turn off the projector, then unplug
responding to all
the power cord and wait at least 30 seconds
controls
before reconnecting power.
2
Lamp burns out or
When the lamp reaches the end of its useful life,
makes a popping
it will burn out and may make a loud popping
sound
sound. If this happens, the projector will not turn
on until the lamp module has been replaced. To
replace the lamp, follow the procedures in the
projector CD manual's "Replacing the Lamp"
section.
3
Image or projector
Please refer to projector CD manual's
problems
troubleshooting.
4
USB/SD read fail
Please make sure the USB device or SD card is
good and well inserted. Remove to try for
several times if necessary. Be reminded that USB
does not support other file format than FAT16/
32. (Ex: NTFS).
5
USB drive fail
USB does not support USB hub function and
which power consumption is over 500mA.
6
Media file not
The files by un-supported codec won't be shown
found or can't be
on file list. Please check the media support table
opened in file list
again in this manual.
All manuals and user guides at all-guides.com
Advertisement
Table of Contents
