Crown CTS SERIES CTS 1200 Catalog page 35

 SPECIFICATIONS
Performance
Sensitivity (for full rated power at 4 ohms):
1.4 Vrms.
Frequency Response
(at 1 watt, 20 Hz to 20 kHz): +0 dB, –1 dB.
Signal-to-Noise Ratio
Rated as dBr to full rated 8 ohms power
output (A-weighted):
XLS1000: > 97 dB.
XLS1500, XLS2000, XLS2500: > 103 dB.
Total Harmonic Distortion (THD): < 0.5%.
Intermodulation Distortion (IMD):
(60 Hz and 7 kHz at 4:1) from full rated
output to –30 dB: < 0.3%.
Damping Factor (8 ohm) 10 Hz to 400 Hz:
> 600.
Crosstalk (below rated 8 ohm power):
at 1 kHz: > 85 dB.
at 20 kHz: > 60 dB.
Input Impedance (nominal):
20 kilohms balanced, 10 kilohms unbalanced.
Load Impedance: 2 to 8 ohms per channel in
Stereo, 4 to 8 ohms in Bridge Mono.
AC Line Voltage and Frequency
Configurations Available (±10%): 120 VAC
60 Hz, 100 VAC 50/60 Hz, 220 and 240 VAC
50 Hz.
Controls
Level: Two front-panel rotary level controls,
one for each channel.
LCD Screen: Back-lit LCD allows for
crossover configuration, amp mode
configuration and clip compressor
configuration.
Menu/Prev/Select: Three buttons located
near the LCD screen that are used to
configure and access the integrated
processing.
Power: Front-panel switch; on when in the IN
position. Blue LED will illuminate when on.
Circuit Breaker: Back-panel breaker provides
overload protection.
T
ake command of center stage with Crown's new XLS amplifiers. The high-
performance class-D amplifier combined with its integrated PureBand™ Crossover
System deliver unmatched performance and sound; while its multiple inputs let
you plug in anything you want. Peak
investment, and at 11 pounds moving from show to show is nearly effortless.
Powerful, flexible, portable, and reliable – RUN THE SHOW with a power amplifier
designed to play hard all night long.
PureBand TM Crossover System
Crossover Filter:
Linkwitz-Riley 24dB per ocatve.
Crossover Mode:
Crossover (CH1=LPF, CH2=HPF),
Low Pass (both channels LPF),
High Pass (both channels HPF),
Bridge (LPF or HPF).
Peak TM Limiters: Channel independent clip
X
limiter designed to provide maximum output
while protecting your loudspeakers.
Indicators
Signal Presence Indicators: Two green LEDs,
one for each channel, illuminate when the
channel's input signal exceeds –40 dBu.
–10 Indicator: Green LED flashes when
output signal exceeds –10 dB below clip.
–20 Indicator: Green LED flashes when
output signal level exceeds –20 dB below clip.
Clip Indicators: Two red LEDs, one for each
channel, illuminate when the channel's output
is being overdriven.
Thermal Indicator: Two red LEDs, one
for each channel, illuminate when thermal
compression begins.
Input/Output
Input Connectors: XLR (one per channel),
1/4 inch (one per channel), and RCA (one per
channel). The 1/4 inch inputs can be used
as loop-thrus to distribute signal to multiple
amplifiers.
Output Connectors: Two 4-Pole Speakon
Output Connectors accept 2-pole or 4-pole
Speakon ® connectors. The top Speakon
connector is wired for both channels so it can
be used for bridge-mono wiring or for stereo
wiring of two speakers to a single Speakon
connector.
One pair of back-panel binding posts per
channel; accepts banana plugs or bare wire.
(European models do not accept banana plugs.)
™ Limiters effortlessly protect your speaker
X
Protection
XLS Series amplifiers provide extensive
protection and diagnostic capabilities,
including output current limiting, DC
protection, circuit breaker, and thermal
protection.
Construction
Ventilation: Flow-through ventilation from
front to back.
Cooling: Internal heat sinks with forced-air
cooling for rapid, uniform heat dissipation.
Air Volume Requirements
(per minute per unit): 80.15 ft³ (2.27 m³).
Dimensions:EIA Standard 19-inch (48.3-cm)
rack mount width (EIA RS-310-B), 3.5-inch
(8.9-cm) height.
XLS1000/1500: 8.10-inch (20.6-cm) depth.
XLS2000/2500: 10.35-inch (26.3-cm) depth.
Weight
Net Weight:
XLS1000: 8.6 lb (3.9 kg)
XLS1500: 8.6 lb (3.9 kg)
XLS2000: 10.75 lb (4.9 kg)
XLS2500: 10.75 lb (4.9 kg)
Shipping Weight:
XLS1000: 13.6 lb (6.2 kg)
XLS1500: 13.6 lb (6.2 kg)
XLS2000: 15.75 lb (7.1 kg)
XLS2500: 15.75 lb (7.1 kg)
Regulatory Certifications
®
Other Applications
P O R T A B L E P A