Hitachi CPX1 Service Manual page 44

Hide thumbs Also See for CPX1:

Table of Contents

When assembling

a. Tighten 7 screws on the bottom and 3 screws on the rear after attaching the upper case with the lamp door

separated.

In order not to make a gap between the upper and the bottom cases, tighten these screws while pressing

down the upper case in the direction of the arrow. Be careful not to bend the outside casing. (Torque:0.39-

0.59N•m)

b. Attach the Lamp door.

3. Replacing the power units.

You have to remove the

dettach the power unit.

Remove the 4 screws to take off the power units.

NOTE : Detaching power unit(circuit)

PCB holder

Push

keep

All manuals and user guides at all-guides.com

CPX1(M1-20)

Optics unit,

Lamp duct and

Stick two pieces of the power unit cushion

to power unit when replacing it.

Lamp door

CAUTION

Tighten this screw using a manual screwdriver.

Lamp house in order of

and

before

Table of Contents

M1-20