DVDO DVDO-Xtend-RX100 HDBaseT 2.0 Receiver with USB and Audio De-embedding User Manual Table of Contents Introduction ...................... 4 Features ....................4 Package Contents ..................5 Specifications .................... 6 Panel Description ..................8 Front Panel ..................8 Rear Panel ..................8 Installation and Wiring..................
DVDO DVDO-Xtend-RX100 HDBaseT 2.0 Receiver with USB and Audio De-embedding User Manual Introduction This product is an HDBT 2.0 receiver that designed to work with an HDBT wall plate transmitter, reliably extending UHD video, multi-channel audio, USB 2.0, RS232 signal and power up to 100m/330ft over a single Cat X cable.
DVDO DVDO-Xtend-RX100 HDBaseT 2.0 Receiver with USB and Audio De-embedding User Manual Built-in PSE to power remote HDBT transmitter Package Contents Before you start the installation of the product, please check the package contents as below: DVDO-Xtend-RX100 Receiver x 1 ...
DVDO DVDO-Xtend-RX100 HDBaseT 2.0 Receiver with USB and Audio De-embedding User Manual Specifications Technical Input 1 x HDBT Input Signal Type HDBT 2.0 VESA: 800x600 , 1024x768 , 1280x768 , 1280x800 1280x960 , 1280x1024 , 1360x768 , 1366x768 1440x900 , 1600x900...
Page 7
DVDO DVDO-Xtend-RX100 HDBaseT 2.0 Receiver with USB and Audio De-embedding User Manual General Power Consumption (Max) Device Dimension 210mm x 25mm x 90.2mm/8.27” x 0.98” x 3.55” (W x H x D) Product Weight 0.46kg/1.01lbs Transmission Distance Note: The use of T568B straight-through Category cables is recommended.
Page 9
DVDO DVDO-Xtend-RX100 HDBaseT 2.0 Receiver with USB and Audio De-embedding User Manual Name Description Unbalanced stereo audio output. • De-embed (left): For audio de-embedding from the HDMI output. AUDIO OUT • Pass Through (right): audio pass-through from Audio IN port on the transmitter to this port.
DVDO DVDO-Xtend-RX100 HDBaseT 2.0 Receiver with USB and Audio De-embedding User Manual RS232 Operation The receiver provides a RS232 port that allowing for RS232 bi-directional serial communication. You can control a RS232-enabled device connected to receiver at transmitter side. Steps to control the RS232 device at transmitter side: Connect RS232: Connect a RS232-enabled device (e.g.
DVDO DVDO-Xtend-RX100 HDBaseT 2.0 Receiver with USB and Audio De-embedding User Manual Warranty Terms and Conditions For the following cases we shall charge for the service(s) claimed for the products if the product is still remediable and the warranty card becomes unenforceable or inapplicable.
Need help?
Do you have a question about the DVDO-Xtend-RX100 and is the answer not in the manual?
Questions and answers