Ip Default Setting; Upgrade Firmware; Using Iap Over Ethernet - Hitachi HX-RIO3 Series User Manual

35

6.10. IP Default Setting

When user forget the IP address, After power on the PIO and push the Reset switch in front of PIO.
The switch should be pushed for 20 seconds at least. PIO will be fall into the factory default mode.
All of PIO LED will blink in Green/Red.
The default IP setting is
IP address
Subnet Mask
Gateway

7. Upgrade Firmware

7.1. Using IAP over Ethernet

(1) Apply a power with pushing a reset button(Mod LED will blink Green/Red).
(2) Execute Firefox.(It is recommended to use Firefox)
(3) Connect to 192.168.100.10 and login (User ID :Hitachi / Password : Hitachi)
192.168.100.100
255.255.255.0
192.168.100.254
HX-RIO3 Series