Pra-Bd11]: List Of Status Led Indication - Pioneer PRA-BD11 Service Manual

5

7.1.2 [PRA-BD11]: LIST OF STATUS LED INDICATION

Show the status indication by LEDs in the following tables. LEDs indicate the version of the firmware for about 10 seconds
immediately after the power was turne on. Then, shift to each status indication.
List of firmware version indications
Version Indication LED1 LED2 LED3
1
2 Unlit
3
4 Unlit
5
List of status indications
+3.3V +3.3V power supply (TH8302, +3.3V regulator BA033 output) OK
+5.0V +5V power supply (TH8301) OK
LED1 unlit .0Test mode, or GS9023A in failure
LED1 lit The SDI audio signals (Ch 1/2) are input.
LED1 blink GS9023A operating normally
Either of the following four cases: (1) Test mode, (2) GS9020A in failure, (3) An SDI signal other than 525i/625i component
LED2 unlit
signal (270 Mbps) is being input, or (4) A copy-protected signal is being input.
The SDI 525i/625i component signal is being input, and an EDH packet is embedded in the SDI input signal. Both GS9020A
LED2 lit
and GS9025A are operating normally.
LED2 blink No SDI input. GS9020A is operating normally.
LED3 unlit When a transmitting machine is not connected: CS8414 in failure When a transmitting machine is connected: A consumer-
format signal is input.
LED3 lit A 48-kHz Fs AES/EBU signal is being input.
LED3 blink Either of two cases: (1) A professional-format signal other than mentioned above is being input, or (2) No AES/EBU input,
and CS8414 is operating normally.
All the LEDs
FPGA in failure
unlit
5
6
Lit Unlit Unlit
Lit Unlit
Lit Lit Unlit
Unlit Lit
Lit Unlit Lit
6
7
LED 3
LED 2
LED 1
PRA-BD11
7
8
A
B
C
D
E
F
37
8