Aquaguard ACRIVE COPPER SUPERB SS User Manual

WHY IS AQUAGUARD® PAANI KA DOCTOR?
• Trust of 15 million+ mothers^
• Owned by 1.62 lakh+ doctors
• Service within 5 kms range of wherever you are
the country
^As per Superbrand and Reader's Digest.
THE POWER OF AQUAGUARD® SUPERB SS
THE POWER OF AQUAGUARD® SUPERB SS
• The new Aquaguard® Superb SS inactivates and removes microbial
contaminants from your water and gives you pure, sweet tasting water.
Superb
disease-causing bacteria, viruses and protozoa-cysts along with other
contaminants like pesticides, residual organic impurities, harmful heavy
metals, arsenic and more, to give you water that is safe and healthy.
Superb
process. This ensures that the water you drink is absolutely pure and crystal clear.
• To ensure good health to you and your family, Aquaguard® Paani Ka Doctor
quality.
KNOW YOUR AQUAGUARD® SUPERB SS
Make sure that your Aquaguard® Superb SS is installed by a trained Eureka Forbes Service
Technician only.
1. Input water must be tested for Total Dissolved Solids (TDS) and Total Hardness.
2. Install your Aquaguard® Superb SS in a dry, ventilated place.
- Keep it away from direct sunlight, heating devices or areas below freezing temperatures.
- You can keep it on the kitchen counter or wall mount it.
Note: Colour, shape and graphic of the product may vary from that shown in this user manual.
IS 10500:2012 Drinking Water Specification (Acceptable Limit)
+
KNOW YOUR AQUAGUARD® SUPERB SS
3. Ensure that the input tap water temperature is in the range of 10°C - 40°C.
-Avoid connection to a hot water tap as it can damage the lter.
4. Make sure that the tap pressure are 0.3 kg/cm
UV+UF and not exceeding 3.0 kg/cm
water pressure is more than the upper limit, installation of PRV*
(Pressure Reducing Valve) is required. If the input water pressure is less than
the lower limit, installation of Booster Pump* is recommended.
5. Flush lters and membrane, thoroughly and independently for 3-5 mins to
remove ne particles present in the lter. This should be done before
the installation of the unit.
Input Water Quality Usage Limitations:
1. If the input water iron content is more than 0.3 mg/L, use of iron remover' is
recommended as a pre-treatment.
2. If the input water turbidity is more than 5 NTU or comprises colloidal particles,
use of a special lter' is required as a pre- lter.
3. Do not install the water puri er if the TDS is more than that prescribed in the
technical speci cations.
"Available at an extra cost.
HERE'S HOW AQUAGUARD® SUPERB RO+SS WORKS
AQUAGUARD® SUPERB RO (with SS TANK)
(WATER FLOW DIAGRAM)
NOTE: THIS IS A SCHEMATIC ILLUSTRATION OF THE PRODUCT TO GIVE A VISUAL SCHEME OF WORKING OF UNITS. THIS IS NOT AN
ACTUAL ENGINEERING DRAWING OF THE PRODUCT.
Patent No. 332771. Patent No. 281750
^^ ++
to 2.0 kg/cm in case of
2 2
in case of RO/RO+UV-MTDS. If the input
2
REJECT FLOW
RESTRICTOR