Compaq 4200 Family User Manual page 53

Lvd disk enclosures
Hide thumbs Also See for 4200 Family:
Table of Contents

Advertisement

GL–4
Enclosure 4200 Family LVD Disk Enclosures User Guide
SCSI ID
spin-up
StorageWorks
terminator
tower
units
VHDCI
Wide-Ultra SCSI
Wide-Ultra2 SCSI
(1.) The bit-significant representation of the SCSI addressing referring to
one of the signal lines numbered 0 through 7 for an 8-bit bus or 0 through
15 for a 16-bit bus. Also referred to as "target ID". (2.) The unique device
identification number assigned to each target or initiator on a single SCSI
bus. The valid address range for a wide bus is 0 through 15.
The process that begins when power is applied to a storage drive, and
ends when the drive is determined to be operational and ready for data
transfer operations.
The Compaq set of enclosure products that allows customers to design
and configure their own storage subsystem. Elements include power,
packaging, and interconnections in a StorageWorks enclosure. Storage
devices, power supplies, I/O modules, EMUs, and array controllers may
be integrated therein to form storage subsystems. System-level enclosures
to house the enclosures are also included.
Interconnect elements that form the ends of the transmission lines in bus
segments. A SCSI domain must have at least one segment and therefore at
least two terminators, except for special cases where the electrical
transmission lines are very short and only one termination or pull–up is
required.
A freestanding, floor mounted unit containing a disk enclosure in the
vertical orientation. This unit can function as a stand-alone storage
subsystem.
The modular unit "U" on which panel heights is based on the vertical
RETMA mounting pattern of 1.750 inches (44.45 mm). (Per EIA
Standard RS-310-C.)
Very High Density Computer Interconnect. A 68-pin interface with
connectors on 0.8 mm centers. Required for Wide-Ultra2 SCSI
configurations.
A SCSI bus that can operate either as an LVD or SE bus. This bus
transfers data at rates up to 40 MB/s when using the LVD protocol. When
using SE the maximum transfer rate is 20 MB/s.
A wide SCSI bus that transfers data at rates up to 80 MB/s when
operating using the LVD protocol. There is no provision for this bus to
operate in the narrow mode.

Advertisement

Table of Contents
loading

This manual is also suitable for:

4200 series

Table of Contents