Table of Contents
Advertisement
Bath Filler
Tap body
Flange
Anti-rotational washer
Backnut washer
Backnut
1. Identify all components and check for completeness, particularly before commencing installation.
2. Remove the backnuts and backnut washers from tap body.
3. Ensuring that the anti-rotational washer is fitted to flange, then fit flange to tap body.
4. Fit the mixer to the bath.
5. Secure the body to the bath by using the backnut washer and backnut below the bath. Do not overtighten.
6. Connect the hot and cold water supplies to the threaded tails of tap body.
7. Turn on the mains water supply letting the water flow for a few minutes to flush through the system.
8. Check all joints and connections for any leaks.
Advertisement
Table of Contents
