Download Print this page
Hide thumbs Also See for D2O RG1:

Advertisement

Quick Links

Operation
1.
INSTALL SOFTWARE
Download & Install
Serial Terminal
Software Application
Powered &
Connected
Device
QR Code to Recommended
Software: Tera Term
Ensure your D2O is connected to the external device.
Open the Serial Terminal software application on your
Computer.
2.
CONNECT TO COMPUTER
4-Pin M12 to
USB-A
2.
1.
TO
COMPUTER
Unscrew Dust Cap and store safely.
Connect 4-Pin M12 to USB-A Cable (sold separately).
3.
PROGRAM & COMMISSION
Refer to the Product Manual for full details and help.
Basic overview - Create a
Serial Connection in your
Serial Terminal software.
Select the D2O's matching
COM port and use the serial
interface parameters shown
in the table.
Once a connection is established press the Enter key
twice to wake the device (allow up to 30secs before
retrying). A Chevron > Character will appear when ready.
• Entering help will provide a list of commands.
• Device will enter sleep after a short timeout, signalled
by GOODBYE message on screen.
• Press the Enter key twice to wake the device again.
4.
ENTER NORMAL OPERATION
TO
DEVICE
Disconnect the 4-Pin M12 to USB-A cable and store for
future use. Replace the Dust Cap on the D2O. Ensure the
device is secure and powered on before leaving.
D
Quick Start Guide
PROPERTY
VALUE
Bit Rate (Speed)
115,200 b/s
Version 1.0
Data bits (Size)
8 bits
May 2021
Parity
None
© Zepiro
Stop Bits
1
Flow Control
None
WELCOME TO YOUR D
This Quick Start Guide will show you the basics of
installing and operating your Rain Gauge Zepiro D2O.
INSTALLATION
Mounting Post Solution
2.5mm Allen Key/Hex Drive
2.0mm Allen Key/Hex Drive
Power must be
enabled before
OPERATION
leaving, using the
command:
A Computer with a Serial Terminal
software application and USB Port
sys -p ON
Zepiro 4-Pin M12 to USB-A Cable
PRODUCT MANUAL
O
RG1
®
2
O RG1
2
- EXTRA ITEMS NEEDED:
(see Installation Step 3)
- EXTRA ITEMS NEEDED:
This Quick Start guide does not
replace the full product manual which
should be consulted for detailed
instructions.
www.zepiro.tech/support/manuals
(sold separately)

Advertisement

loading

Summary of Contents for ZEPIRO D2O RG1

  • Page 1 Ensure your D2O is connected to the external device. • Device will enter sleep after a short timeout, signalled installing and operating your Rain Gauge Zepiro D2O. Open the Serial Terminal software application on your by GOODBYE message on screen.
  • Page 2 Installation SITE SELECTION PREPARE MOUNTING POST CONNECT INTERFACE CABLE *NPS DN 25mm / 1” AS/NZS1163 | ASTM 153M White Not Used 90° Brown Not Used Green Signal GND >26mm Yellow Not Used INTERNAL DIA. Purple Not Used Pink Wire Fault - Terminate with PIN 3 Blue Pulse Input...