WatchDog LT Quick Start Manual

Watchdog Tracker LT
"Quick-Start" Setup Guide
Package Contains:
Tracker LT Monitor Unit
Includes monitor unit with connection
harness cable attached and antenna.
Adapter (for 3"
riser pipe
installations)
*Please inspect package contents and immediately notify
Elecsys Technical Support at (913) 825-6366 or email
support@watchdogcp.com if there are any discrepancies.
Prior to beginning installation of this product, locate
the serial number of the device on the label attached
to the back of the enclosure and record it for use in
setting up the website.
Ser. #_________________________
Tracker LT Wiring Diagram
Basic Testpoint Monitoring: Connect the brown wire to the pipeline lead, connect the yellow wire
to the reference electrode lead.
Single Coupon (instant-off) Test Station Monitoring: Connect brown wire to the pipeline lead,
yellow wire to the reference electrode lead, and blue/white wire to the coupon lead (Tracker LT
supports single coupon connection only).
Critical Bond Monitoring: Connect the red/white lead to the "shunt +" connection, and connect the
orange/white wire to the "shunt –" connection. If structure-to-soil connections are desired, connect
the brown wire to the critical structure lead, connect the yellow wire to the reference electrode lead,
and connect the blue/white wire to the second structure lead.
1. To activate the Tracker Monitor Unit, Press and hold the button on the side of the unit for approximately 4 seconds
until the "Power" LED turns on solid then release to initialize communication to the website. While initializing
communication with the cellular network, the LED will flash in a steady "On/Off" sequence. The LED will turn off
when the initial communication is completed. When communication is made with the website, the website will
send the latest configuration to the unit.
2. The Tracker unit will obtain measurements for all of the configured channels and forward the data to the website.
The Tracker unit will automatically go into "sleep" mode until the next measurement cycle.
3.
Activation and LCD Display
Tracker Setup Guide P/N
REV B
81-0059-00