M.F. Blouin FP01568P10 Assembly Instructions

2-sided black floor poster stand with 10-pocket

ASSEMBLY INSTRUCTIONS

Parts & Hardware

Prior to assembly, please be sure all of the parts and hardware are present.

If you are missing any hardware, please call immediately.

Acrylic 10-Pocket

Literature Holder

Black Spacer Panel

(2) Black Legs

(2) Hex Bolts

Hex Wrench

(8) Acrylic Removable Pegs

(For Literature Holder)

M.F. BLOUIN

Merchandising Solution

2-Sided Black Floor Poster Stand with 10-Pocket

Acrylic Sign Holder

Black Base

(2) Threaded Rods

(4) Lock Knobs

710 Main St. Rollinsford, NH 03869 • 1-800-394-1632 • www.mfblouin.com • info@mfblouin.com

Product No. FP01568P10

Page-1

Table of Contents

Need help?

Do you have a question about the FP01568P10 and is the answer not in the manual?

Page 1 2-Sided Black Floor Poster Stand with 10-Pocket ASSEMBLY INSTRUCTIONS Product No. FP01568P10 Parts & Hardware Prior to assembly, please be sure all of the parts and hardware are present. If you are missing any hardware, please call immediately. Acrylic 10-Pocket...
Page 2 2-Sided Black Floor Poster Stand with 10-Pocket ASSEMBLY INSTRUCTIONS Product No. FP01568P10 Tighten legs keeping slots aligned Step 1: Attach the black legs to base unit using the supplied hex bolts & hex wrench - Position each leg keeping keeping the top slots aligned. Hold each leg in place while tightening the bolt(s) with the hex wrench.
Page 3 2-Sided Black Floor Poster Stand with 10-Pocket ASSEMBLY INSTRUCTIONS Product No. FP01568P10 Step 2: After removing the poster holder & spacer panel from its packaging, peel off the protective film and insert the spacer panel between the two sides Step 3: of the sign holder keeping the curved corners to the bottom and roughly aligning the holes.
Page 4 2-Sided Black Floor Poster Stand with 10-Pocket ASSEMBLY INSTRUCTIONS Product No. FP01568P10 Step 4: Align the two holes in the back of the 10-pocket literature holder with the holes in the legs/sign holder. Insert the threaded rods through the holes and tighten the lock knobs over each end.