Advanced Operation - Cobra MR F55 Owner's Manual

Advanced Operation

Intro Operation Customer Warranty
Operating Your Radio
Assistance
Intro Operation Customer
Assistance
Dual-Watch
Dual-Watch gives you one (1) button access to scan the two (2) locations of most
Customer
Installation
Assistance
importance to you. Channel 16 will always be included as a scanned location. The
remaining location will be the VHF channel in effect when you enter Dual-Watch mode.
condary Icons
Customer
Installation
Assistance
NOTE
Secondary Icons
The radio must be squelched for dual-watch to function. See page 36
Notice Caution Warning
for squelch procedure.
To Enter Dual-Watch Mode:
Standby Mode
Notice Caution
1. In Standby mode, use the Up/Down buttons to go
to the channel you want to add as the second location
to be scanned.
2. Press the Dual-Watch button.
Dual-watch will be indicated on the LCD and the radio
Dual-Watch Button
will scan between Channel 16 and the second dual-watch
location you selected. A signal on any one (1) of the two (2)
channels will stop the scan to allow you to listen to the traffic
on the channel. The channel number will be displayed on
the LCD.
To Exit Dual-Watch Mode:
1. Press the Dual-Watch button. The radio will
return to Standby mode.
During Dual-Watch (while receiving an incoming
Dual-Watch Mode
transmission), You Can Choose From The Following:
a. Press the Talk button to remain on that
dual-watch location and return to Standby mode.
b. Press the Up/Down buttons to resume scanning
dual-watch locations.
If you do not press any buttons, your radio will
automatically resume scanning dual-watch locations
when the incoming transmission is complete.
During Dual-Watch (while not receiving a transmission):
a. Press the Talk button to communicate on the last
dual-watch location scanned and return to Standby mode.
46 English
Warranty
88
75
Warning
88
Main Icons
Operating Your Radio
Intro Operation
Intro
Scanning
15
Installation
30 88 30
Secondary Icons
Secondary Icons
60 60
75
Scan Button
14
68
69
79
A
72
78
A
Scan
Advanced Operation
Customer Warranty
Operation Assistance Customer Warranty
Scan
Assistance
During Scan, the radio will rapidly switch from channel
to channel through all the channels. Whenever any activity
is detected, the radio will stop the scan for ten (10) seconds
Customer
Customer
Installation
Assistance Assistance
to allow you to listen briefly on that channel. It will then
continue to scan unless you switch out of the Scan mode.
NOTE
The radio must be squelched for Scan mode to
Notice Caution Warning
function. See page 36 for squelch procedure.
Notice Caution Warning
To Enter Scan:
1. From Standby mode, press the Scan button.
The radio will immediately begin to scan the entire channel
map selected in the active channel map.
71
on the LCD.
To Exit Scan:
1. From Scan mode, press the Scan button.
This will return the radio to Standby mode on the last
scanned channel.
During Scan (while receiving an incoming transmission),
You Can Choose From The Following:
a. Press the Talk button to remain on that channel and end
scanning. This will return the radio to Standby mode.
b. Press the Up/Down buttons to resume scanning.
If you do not press any buttons within ten (10) seconds,
your radio will automatically resume scanning.
During Scan (while not receiving a transmission):
a. Press the Talk button to communicate on the last
channel scanned and return to Standby mode.
will show
SCAN
Nothing comes close to a Cobra ®
47