Step 3:
Connect two screen tubes (D) with one vertical connector to form a short pole
•
assembly. Repeat this process again so you have two screen pole assemblies.
•
Slot the screen pole assemblies through either side of the projector screen and
connect them with the 3-way connectors placed in step 1.
x2
Step 4:
•
Form another long pole assembly as instructed in step 2.
•
Slot the long pole assembly through the top edge of the projector screen.
Place one bend connector (H) on each end of the long pole assembly and connect
•
the bend connectors with the top ends of the screen pole assemblies slotted in step
3.