Operation - VGE Blue Lagoon SPA UV-C 12 WATT Manual

OPERATION

EN
The special Philips UV-C lamp in the Blue Lagoon Spa UV-C generates UV-C radiation with
a wavelength of 253.7 nm, and this ensures the destruction of bacteria, moulds and viruses.
This lamp has been specially designed by Philips, and is ideal for water temperatures up to 40
degrees Celsius. The Blue Lagoon Spa UV-C ensures fresh, clean and clear water in an efficient and
environmentally-friendly manner. The water is guided through the UV-C device by means of a
pump. The UV-C radiation neutralises bacteria, viruses and other primitive organisms and prevents
their reproduction. The Blue Lagoon Spa UV-C has an integrated electronic ballast. This ballast
ensures maximum lamp performances. Thanks to the Blue Lagoon Spa UV-C, your water will be
disinfected efficiently and safely, and the quality of your water will remain excellent. The device can
be connected using PVC tube or hose.
INSTALLATION OF THE UV-C DEVICE (DRAWING 1)
The ideal place for the installation of the device is immediately behind the filter. Never submerge
this device in water. Always install the device outside of the pool. Ensure that there is always water
flowing through the unit if the lamp is on.
1. Determine where the device will be installed. (always install vertically, see Drawing 3).
2. Fit the unit into the circuit using the three-part couplings (F).
3. Connect the end of the cable (D) to the top of the lamp (A).
4. Activate the pump and check the flow and any leakage of the system.
5. Insert the plug of the UV-C device into a wall socket with a safety ground and fitted with an residual
current circuit-breaker (max 30 mA). Check that the lamp is on by looking through the transparent
components of the device. The unit is switched off by pulling the plug out of the socket.
4 | BLUE LAGOON SPA UV-C 12 & 15 WATT
Please read carefully through these instructions
for use before installing this device.
CAUTION:
Carefully read these instructions before installing this device.
It's not permitted to flow a liquid through
the reactor or to add additions to the
water that has to be treated, which can
have a negative effect on corrosion
or degradation on the used materials.
This to avoid dangerous situations or
damage to the reactor and surrounding
installations and/or to the flora and fauna.
The quartz glass and the UV-C lamp will
stay warm for quite some time after the
device has been switched off. It has a
cooling time of at least 15 minutes.
The UV-C lamp should never be
turned on when there's no flow.
Radiation of this ultraviolet lamp is
dangerous for eyes and skin.
Wear gloves to protect the quartz glass
and UV-C lamp against fingerprints.
Fingerprints can burn into the quartz
glass and UV-C lamp while turned on,
causing reduction of the disinfection.
Wear safety glasses during
maintenance and installation.