Advertisement
Battery
Replacement
• Open the fasteners on the back of the toy.
Remove the electronics unit from inside
the toy.
• Loosen the screws in the electronics unit
battery compartment door with a Phillips
screwdriver. Remove the door.
• Remove the exhausted batteries and
properly dispose.
• Insert three, new AA (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screws. Do not over-tighten.
• Fit the electronics unit back inside the toy.
Make sure the button on the electronics unit
is facing the front of the toy.
• If this toy begins to operate erratically, you
may need to reset the electronics. Slide the
power/volume switch off and then back on.
• When sound or light from this toy become
faint or stop, it's time for an adult to change
the batteries.
1,5V x 3
AA (LR6)
For longer life, use
alkaline batteries.
Power and
Mode Switches
• Slide the power/volume switch to ON with
low volume
, ON with high volume
OFF .
• Choose a mode and close the fasteners.
Short Play - Watch bunny's belly
light and Listen to a short song with
each press.
Long Play - Press bunny's belly for
three minutes of glowing light and about
20 minutes of soothing music. To turn
light back on, press bunny's belly again.
or
Advertisement
