Dell P2722H Disassembly Procedure page 3

3
DELL P2722H
Put the panel module on a protective cushion, then
disconnect the panel lamp cable from the connector
S14
of panel module, then unplug the LVDS cable from
the connector of the panel module.
Take away the bracket chassis module and then put
S15
the bracket chassis module on a protective cushion.
Remove the black Mylar from the hooks of the
S16
bracket as the picture below shown.
Use a Hex-head screwdriver to remove two screws
S17
for unlocking the D-Sub connector.
(No.1~2 screws size=M3x8, Torque=6±0.5kgfxcm)
2
1
Use a Philips-head screwdriver to remove 5pcs
screws for unlocking the power board and interface
board, and then release all the cables from the
S18
hooks.
(No.1~4 screw size=M3x7.5, Torque=6±0.5kgfxcm;
No.5 screw size=M4x8, Torque=6±0.5kgfxcm)
4
Remove the interface board and power board from
S19
the bracket chassis module carefully, and disconnect
all the cables.
3
1
2
6