Table of Contents
Advertisement
Menu Operation
1. Use the On Screen Display menu to set and adjust functions
2. Use 【P+】/【P-】 to select the desired menu after pressing【MENU】, then press 【V+】
/【OK】to enter the next submenu; Use 【V+】/【V-】to adjust the options value and return
to the previous menu by pressing 【MENU】again. The menu will disappear without any
operation within 10 seconds.
Function Introduction
In TV, AV, RGB, YPbPr and PC modes
Ⅰ Picture
● Brightness
To adjust the picture's brightness
● Contrast
To adjust the picture's contrast.
● Sharpness
To adjust the picture's definition.
● Colour
To adjust the picture's colour.
● Tint
To adjust the picture's tint. (For NTSC signal only)
Note: Picture menu options in other signal sources. AV/RGB: the same as in TV mode
YPbPr/PC: only two options of Brightness and Contrast
ⅡSound
● Volume
To increase or decrease the volume.
● Balance
To balance the volume between the left and right
speakers.
● Woofer
To turn on/off the woofer.
● Spatial
To turn on/off the surround.
● Equalizer (submenu)
Use 【 OK 】 / 【 V+ 】 to enter the Equalizer
(submenu), you can increase or decrease the value
of the sound output in every frequency band
preferred
Note: The Audio menu options are the same in TV
signal as well as in other signal sources
Ⅲ Setup
● Language
PAGE 12
Advertisement
Table of Contents
