Summary of Contents for Challenger SMART FORCE ASFCAM3
Page 1
ASFCAM3 1080P Outdoor Wireless IP Camera Installation Instructions General Introduction Description of Cables Connectors: The IP Camera is compatible with the SmartForce system designed to monitor Reset wires an outdoor area where it can send video images to the server. The recording DC Power function will be activated if an event is triggered under warning conditions.
Operation Live video 1. To watch live video of the camera, go to LIVE, and click on any image. 4. Select “Camera”. 2. Click the snapshot image to view live view images. Playback Recorded Videos 1. To display recorded videos, go to VIDEO page. All videos are displayed with 5.
4. Unplug both the power and Ethernet cable from the camera. 5. Plug back only the power connector, leaving the Ethernet cable disconnected. 6. The camera will power on, followed by flashing red LED. 7. After one minute the LED will flash blue rapidly, this means the camera is waiting to scan a QR code.
Troubleshooting Signal strength: LED Colour The below table lists some possible causes and solutions. Strong Constant Blue LED Normal Constant Purple LED Symptom Possible Cause Recommendation The LED never turns There is no power Check the camera’s connection to Weak Constant Red LED or not connected the power adapter and ensure...
Errors and omissions excepted. These instructions have been Flashing Blue slowly Connecting to Wi-Fi carefully checked prior to publication. However, no responsibility can be accepted by Challenger for any misinterpretation of these instructions. Flashing Purple Wrong Wi-Fi password Flashing Blue Setting camera…...