Reset - Canon MiniTT1 Owner's Manual

Reset

The MiniTT1 and FlexTT5 can be reset in the field.
There are two types of reset.
RESET A:
Returns both C.1 and C.2 to the channels you last set
in the PocketWizard Utility. Reset A is primarily used for resetting
channels that were taught in the field.
1. Turn the radio off
2. While holding TEST, slide the power switch to C.1 (C.1 and C.2
are always reset together).
3. Hold TEST for a few moments until you see 2
are restored to their last Utility values. If you've never set the channels using the Utility, then
the channels are restored to factory defaults.
RESET B:
Returns all of your radio's settings, including channels and all settings from the
PocketWizard Utility, to factory defaults.
1. Turn the radio off
2. While holding TEST, slide the power switch to C.1 (C.1 and C.2 are always reset together).
3. Hold TEST for ~10 seconds until you see 4
to factory defaults.
Default Settings:
ControlTL Tx Channel = 1
Standard Tx Channel = 1
Use ControlTL for Rx Channel = Enabled
ControlTL Rx Channel = 1
Camera Model = Auto
28
green
blinks, then release TEST. The channels
green
blinks, then release TEST. The radio is reset
HyperSync Offset = -170
Remote TTL Flash Sleep Delay = Disabled
Flash Idle Time Out Mode = Disabled
Force TTL Master Mode = Disabled
Bottom Shoe = Enabled
Flex TEST button