Bearing Installation
The two circlips must be installed before the bearings are pressed into the bottom bracket
shell using a special 3-piece bearing driver tool KT010/.
use with a headset cup bearing press with 1" adapters. such as Park Tool HHP-2 . Consult
the graphic below for the arrangement of the tool parts. The headset press needed is not
shown.
1.
Drive one bearing at a time and apply a high-quality bicycle bearing grease to the BB
shell inside surfaces prior to installing the bearings.
Install the first bearing like this.
Cannondale Tools
Kit # KT010/
Figure 2
Install the second bearing like this. Notice the one
tool part is not in use.
The tool parts are designed for
10