Page 1
Made SiMpLe! N E V E R G E T L O S T A G A I N Quick Start Guide Model #: 360200 Lit# 98-1586/04-10...
Page 2
Full instruction Manual available online at: www.bushnell.com/manuals/gps Control & display Guide Battery Indicator POWER Button MARK Button Local Time Satellite Locked Icon Direction to Location DOWN Button UP Button Distance to Location Location Memory Icon (1 of 5 shown) Note: Control Buttons are located on the sides of the BackTrack...
Page 3
Unlock position Lock position 1. Open the battery cover and insert two AAA batteries. Hold pOWeR Button GpS Satellite Reception icon Take the BackTrack Outdoors 2. Hold pOWeR button (until the display appears) to turn on the BackTrack. When satellite icon stops blinking, it is ready to use (be sure you are outdoors with a clear view of the sky).
Page 4
press Up 3. The Location screen will display when first turned on. The time is displayed but may need to be adjusted for your time zone. Go to Settings Mode to change the time (as well as other units of measurement). Press Up button on right side of unit to access Settings Mode.
Page 5
press Up Hour Format selected Settings Mode 5. In Settings Mode, you may also change the other unit measurements. Press the Up or dOWN buttons to highlight the setting. Press the MaRK button to change the unit measurement. You can change hour (12h to 24h), distance units (yards/miles to meters/kilometers), and temperature units (Fahrenheit to Celsius).
Page 6
Stand at the location you want to mark as “Home” 7. Select an icon you want to use. While you are physically at the location you want to mark (i.e. your campsite), press and hold the MaRK button until you see the display change as shown at right above, confirming the location is stored. Note: it does not matter which direction you face when marking a location.
Page 7
HOLd pOWeR to turn unit back on. display shows distance & direction to the most recently marked location. Note: the distance units will automatically change from “yd” to “mi” when you are a great enough pOWeR distance away from the location. 9.
Page 8
press dOWN Location Screen 10. BackTrack Point-5 also provides two additional screens with useful information for outdoor enthusiasts. Press the dOWN button while on the Location screen. You will see a screen that displays the air temperature and altitude of your current location. Press dOWN again to view the Compass screen, which displays your current heading in degrees, minutes, and seconds.
Automatic Distance Units Switching The BackTrack will automatically switch from yards to miles (or meters to km) for longer distances. It can display up a maximum distance of 999 miles or kilometers. Auto Power Off Power automatically turns off after 5 minutes if no buttons have been pressed. Or you may hold down the pOWeR button to turn the unit off manually.
Liability Notice: In no event shall Bushnell be liable for any incidental, special, indirect or consequential damages, whether resulting from the use, misuse, or inability to use this product or from defects in the product. Some states do not allow the exclusion of incidental or consequential damages, so the above limitations may not apply to you.
This warranty does not cover damages caused by misuse, improper handling, installation, or maintenance provided by someone other than a Bushnell Authorized Service Department. Any return made under this warranty must be accompanied by the items listed below: 1) A check/money order in the amount of $10.00 to cover the cost of postage and handling...
Need help?
Do you have a question about the BACKTRACK 360200 and is the answer not in the manual?
Questions and answers