Related Manuals for FM Systems ACE472
Summary of Contents for FM Systems ACE472
- Page 1 ACE472 AUTOMATIC CABLE EQUALIZATION AMPLIFIER INSTRUCTION MANUAL IB 641402 COPYRIGHT ALL RIGHTS RESERVED 8-10-2005...
- Page 2 HOW AND WHERE TO MOUNT THE UNIT MODUAL CARD INSTALLATION HOW TO CABLE THE UNIT POWER SUPPLY INSTALLATION SET-UP OF THE UNIT OPERATION FRONT PANEL INDICATORS BY-PASS PUSH BUTTON OPERATION CARE AND MAINTENANCE OF THE ACE472 ACE472.ISB PAGE 1 OF 4...
-
Page 3: Shipping Inspection
Designator this instruction book. If an RMS-400 Mainframe and Power Supply was purchased with a ACE472 Card, the Card will be installed at the factory into the Mainframe with labels attached and the retaining screw engaged and locked. HOW AND WHERE TO MOUNT THE UNIT Select a position for the RMS-400 that is near the video recorder, monitor or other equipment that needs video control. -
Page 4: Operation
There are two separate video outputs on each channel so that two video circuits may be driven at once with the same video signal. The "VIDEO OUTPUTS" of the ACE472 have a 75 Ohm output impedance to match standard video cable. Be sure the equipment being driven is... -
Page 5: Front Panel Indicators
BY-PASS PUSH BUTTON OPERATION The ACE472 has a by-pass mode of operation. The switch on the front panel is used to set the amplifier and equalizer to unity gain, (no correction). With this push button you can make a quick comparison between active control and no control.