Table of Contents

Advertisement

Available languages

Available languages

Storage Electric Water Heater
Instruction Manual
Model: D30-15FA2
D50-15FA2
D80-15FA2
D100-15FA2
The diagram above is just for reference. Please take the
appearance of the actual product as the standard.
Thank you very much for purchasing our water heater.
Before installing and operating your water heater, please
read this manual carefully and keep it for future reference.

Advertisement

Chapters

Table of Contents
loading
Need help?

Need help?

Do you have a question about the D30-15FA2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Midea D30-15FA2

  • Page 1 Storage Electric Water Heater Instruction Manual Model: D30-15FA2 D50-15FA2 D80-15FA2 D100-15FA2 The diagram above is just for reference. Please take the appearance of the actual product as the standard. Thank you very much for purchasing our water heater. Before installing and operating your water heater, please...
  • Page 2: Table Of Contents

    General Remark ● The installation and maintenance has to be carried out by qualified professials or Midea authorized technicians. ● The manufacturer shall not be held responsible for any damage or malfunction caused by wrong installation or failing to comply with following instructions included in this pamphlet.
  • Page 3: Cautions

    1. CAUTIONS Before installing this water heater,check and confirm that the earthing on the supply socket is reliably grounded. Otherwise, the electrical water heater can not be installed and used. Do not use extension boards. Incorrect installation and use of this electrical water heater may result in serious injuries and loss of property.
  • Page 4: Product Introduction

    Rated Max Of Water Water Volume Protection Model Power Voltage Pressure Temperature Proof Class (MPa) (°C) Class (ACV) D30-15FA2 1500 220-240 IPX4 D50-15FA2 1500 220-240 IPX4 D80-15FA2 1500 220-240 IPX4 D100-15FA2 1500 220-240 IPX4 2.2 Brief introduction of product structure...
  • Page 5 D30-15FA2 D50-15FA2 D80-15FA2 D100-15FA2 (Note:All dimensions are in mm) 2.3 Internal Wire Diagram Thermal Thermostat Cut Out Brown Blue Yellow/Green WIRING DIAGRAM...
  • Page 6: Unit Installation

    3. UNIT INSTALLATION 3.1 Installation Instruction ① This electrical water heater shall be installed on a solid wall. If the strength of the wall cannot bear the load equal to two times of the total weight of the heater filled fully with water, it is then necessary to install a special support.
  • Page 7 Cold water inlet Hot water outlet Pressure relief valve Pressure release hole Adjusting handle for Joint screw for cold water inlet mixing valve Hot water (Fig.4) ④ If the users want to realize a multi-way supply system, refer to the method shown in fig.5 for connection of the pipelines.
  • Page 8: Methods Of Using

    4. METHODS OF USING ● First, open any one of the outlet valves at the outlet of the water heater, then, open the inlet valve. The water heater gets filled with water. When water flows out of the outlet pipe it implies that the heater has been filled fully with water, and the outlet valve can be closed.
  • Page 9: Troubleshooting

    6. TROUBLESHOOTING Failures Reasons Treatment The heating indicator Failures of the temperature Contact with the professional light is off. controller. personnel for repair. 1. Wait for restoration of 1. The running water supply running water supply. is cut off. 2. Use the heater again when No water coming out 2.
  • Page 10: Produce Information With Eu Regulation

    7. Produce information with EU regulation The electrical storage water heater D30-15FA2 of the company MIDEA Ltd. was tested with a declared load profile of the size “S” The product fulfills and corresponds to the requirements of the commission regulation standards (No 814/2013) for electrical storage water heater and achieved a water heating energy efficiency of η...
  • Page 11 The electrical storage water heater D50-15FA2 of the company MIDEA Ltd. was tested with a declared load profile of the size “M” The product fulfills and corresponds to the requirements of the commission regulation standards (No 814/2013) for electrical storage water heater and achieved a water heating energy efficiency of η...
  • Page 12 The electrical storage water heater D80-15FA2 of the company MIDEA Ltd. was tested with a declared load profile of the size “M” The product fulfills and corresponds to the requirements of the commission regulation standards (No 814/2013) for electrical storage water heater and achieved a water heating energy efficiency of η...
  • Page 13 The electrical storage water heater D100-15FA2 of the company MIDEA Ltd. was tested with a declared load profile of the size “M” The product fulfills and corresponds to the requirements of the commission regulation standards (No 814/2013) for electrical storage water heater and achieved a water heating energy efficiency of η...
  • Page 14 The product is subject to change without notice. Please keep this manual properly. Midea Italia S.r.l. A Socio Unico Viale Bodio 29 20158 Milano (MI) www.midea.com/it www.midea.com/global...
  • Page 15 Scaldabagno elettrico Manuale Utente e di installazione Modello D30-15FA2 D50-15FA2 D80-15FA2 D100-15FA2 Il diagramma sopra è solo per riferimento. Si prega di considerare come standard l'apparenza del prodotto concreto. I disegni e le informazioni grafiche contenute in questo volume sono solo indicative. L'aspetto effettivo di prodotti e accessori...
  • Page 16 Indicazioni generali ● autorizzati. ● Il produttore non deve essere ritenuto responsabile per qualsiasi danno o malfunzionamento causato da installazione errata o dal mancato rispetto delle istruzioni incluse in questo libretto. ● Per delle linee guida su installazione e manutenzione più dettagliate, fare riferimento ai capitoli sotto.
  • Page 17: Precauzoni

    1. PRECAUZIONI Prima di installare questo scaldabagno, verificare che l'alimentazione elettrica sia correttamente connessa e che la connessione di messa a terra sia adeguata. In caso contrario, lo scaldabagno non può essere installato e utilizzato. Non utilizzare prolunghe. l'installazione e utilizzo non corretto di questo scaldabagno può...
  • Page 18: Introduzione Prodotto

    Tensione Pressione Temperatura Volume Classe di Classe di Modello nominale nominale nominale acqua massima protezione impermeabilità (ACV) (MPa) (°C) D30-15FA2 1500 220-240 IPX4 D50-15FA2 1500 220-240 IPX4 D80-15FA2 1500 220-240 IPX4 D100-15FA2 1500 220-240 IPX4 2.2 Breve introduzione della struttura del prodotto...
  • Page 19 D30-15FA2 D50-15FA2 D80-15FA2 D100-15FA (Nota: tutte le dimensioni sono in mm) 2.3 Diagramma cavi interni Protezione termica Termostato Marrone Giallo/Verde SCHEMA ELETTRICO...
  • Page 20: Installazione Unità

    3. INSTALLAZIONE UNITÀ 3.1 Istruzioni installazione Questo scaldabagno deve essere installato su una parete solida. Se la parete non è in grado di sorreggere più di due volte del peso dell'elettrodomestico completamente pieno d'acqua, è necessario installare un supporto speciale. Nel caso in cui la parete sia in mattoni forati, assicurarsi di riempirli di cemento completamente.
  • Page 21 Ingresso acqua fredda Uscita acqua calda Valvola di rilascio pressione Foro di rilascio pressione Manico di regolazione Vite collegamento ingresso acqua fredda per valvola di mescolatura Acqua calda (Fig.4) Nel caso in cui l'utente volesse realizzare un sistema di fornitura multiplo, fare riferimento al Valvola di rilascio pressione Valvola di ingresso d’acqua Triplo collegamento Uscita acqua...
  • Page 22: Metodi Di Utilizzo

    4. METODI DI UTILIZZO ● Aprire una delle valvole di uscita dello scaldabagno, successivamente aprire la valvola di entrata. Lo scaldabagno si riempie d'acqua. Se esce dell'acqua dalla tubo di uscita vuol dire che lo scaldabagno è pieno e la valvola di uscita può essere chiusa. NOTA: Durante l'utilizzo normale, la valvola di ingresso deve essere tenuta aperta.
  • Page 23: Risoluzione Problemi

    6. RISOLUZIONE PROBLEMI Guasti Cause Soluzione L'indicatore di riscaldamento è Guasto del sistema di controllo Contattare un professionista spento temperatura 1. Attendere la riattivazione della 1. La fornitura d'acqua è fornitura d'acqua. interrotta. 2. Utilizzare lo scaldabagno di Non esce acqua dall'uscita 2.
  • Page 24: Informazioni Prodotto Con Normativa Ue

    7. Informazioni prodotto con normativa UE Lo scaldabagno elettrico D30-15FA2 della società MIDEA Ltd. è stato testato con un carico di profilodichiarato di dimensioni "S". Il prodotto soddisfa e corrisponde ai requisiti degli standard normativi (No 814/2013) per gli scaldabagno elettrici e possiede un'efficienza energetic di η...
  • Page 25 Lo scaldabagno elettrico D50-15FA2 della società MIDEA Ltd. è stato testato con un carico di profilodichiarato di dimensioni "M". Il prodotto soddisfa e corrisponde ai requisiti degli standard normativi (No 814/2013) per gli scaldabagno elettrici e possiede un'efficienza energetic di η...
  • Page 26 Lo scaldabagno elettrico D80-15FA2 della società MIDEA Ltd. è stato testato con un carico di profilodichiarato di dimensioni "M". Il prodotto soddisfa e corrisponde ai requisiti degli standard normativi (No 814/2013) per gli scaldabagno elettrici e possiede un'efficienza energetic di η...
  • Page 27 Lo scaldabagno elettrico D100-15FA2 della società MIDEA Ltd. è stato testato con un carico di profilodichiarato di dimensioni "M". Il prodotto soddisfa e corrisponde ai requisiti degli standard normativi (No 814/2013) per gli scaldabagno elettrici e possiede un'efficienza energetic di η...
  • Page 28 Questo prodotto sarà soggetto a cambiamenti senza preavvisi Conservare correttamente questo manuale Midea Italia S.r.l. A Socio Unico Viale Bodio 29 20158 Milano (MI) www.midea.com/it www.midea.com/global...

This manual is also suitable for:

D50-15fa2D80-15fa2D100-15fa2

Table of Contents