Table of Contents
Advertisement
Menu structure overview
C If the display is shown with a deci-
mal point, multiply the indicated
value by 100
D The units described in these
instructions are only equipped
with one compressor
Scanning and changing parameters
Example:
1. In the standard display (see the
overview of the menu structure on
page 33) press "mode" and "on/off"
simultaneously for less than 2 s.
The next lower menu level will be
shown.
2. With "
" or "
down through the menu, until the
required parameter group is dis-
played.
3. Press "
" and "
neously for less than 2 s.
The next lower menu level will be
shown.
Code entry
The access to some of the parameters
in the control unit is protected by a
code.
(cont.)
4. With "
5. To change the parameter, increase
" scroll up or
6. To save the change and to exit the
7. To return to the standard display,
" simulta-
Control settings
" or "
" scroll up or
down through the menu, until the
required parameter is displayed.
or reduce the value with "
"
", or change the option from
ON to OFF or vice-versa.
menu level, press "
simultaneously for longer than 2 s.
repeat step 6 several times, if
required.
" or
" and "
"
35
Advertisement
Table of Contents
