Seima PAXI ISLAND Installation Manual

1700 bath

Advertisement

I N S TA L L AT I O N G U I D E
PAXI ISLAND 1700 BATH
Important — read this first!
1
Inspect the bath before installation, to ensure there are no visible defects. If a defect is found, do not install the bath and
contact the supplier immediately. Claims for defects will not be accepted after the product has been installed.
2
The bath must be installed by a licensed tradesperson. Failure to do so may void the warranty.
3
Compliance with AS.3740 Waterproofing of Wet Areas within Residential Buildings applies when installing baths.
4
Local authorities may have specific installation requirements and this should be checked before installation.
5
Grade the bath sub-floor in accordance with requirements of local authorities. Grade sub-floor 1:60 minimum.
6
The protective film on the bath should be left intact during installation and should remain on the bath until first use.

Protective film | Care and maintenance of the bath surface

There is a protective film on the acrylic surface of the bath at the time of purchase. This should remain intact until the bath
1
is ready to use to protect the bath during installation.
2
To preserve its polished finish, this bath should be cleaned with a soft cloth using warm, soapy water or household
detergent. Do not use abrasive cleaning products.
3
If accidental scratches, abrasions or burns occur, the surface finish can be restored by gentle polishing with Brasso.
4
For full warranty terms and conditions, please visit seima.com.au

Base support for the bath

1
The design of acrylic baths allows the base of the bath to be supported by three timber support battens.
2
Position and fix timber support battens to the base of the bath and the floor, using a suitable floor and wall panelling
adhesive. Ensure that the bath is neatly fitted and properly supported.
3
During installation, use a spirit level to check that the bath rim is level.
s e i m a . c o m . a u
Ensure that the rim of the bath is level, using a spirit level.
timber support battens
Please note
All measurements are in millimetres.
Dimensions are nominal and subject to normal ceramic manufacturing variations of ±5mm.
Fixing: Use acetic cured silicone sealant. Do not use epoxy type adhesives.
Specifications may vary without notice as part of our continuous improvement practices.
Clean with a damp cloth. Do not use abrasive cleaners, liquids or pastes.
Please leave this guide
with the end user.
paxi-island-in | v 1.0 | page 1 of 2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PAXI ISLAND and is the answer not in the manual?

Questions and answers

Summary of Contents for Seima PAXI ISLAND

  • Page 1 Do not use abrasive cleaning products. If accidental scratches, abrasions or burns occur, the surface finish can be restored by gentle polishing with Brasso. For full warranty terms and conditions, please visit seima.com.au Base support for the bath The design of acrylic baths allows the base of the bath to be supported by three timber support battens.
  • Page 2 Paxi Island bath installation Island installation — see diagram below — there is a ledge between the wall and the side of the bath. The minimum setout from the wall is 100mm. Refer to the local authority for local setout requirements.

Table of Contents