Seima TONDO INSET Installation Manual

I N S TA L L AT I O N G U I D E
SELECT + TONDO INSET BATHS
SUITABLE FOR BUILT-IN AND ISLAND INSTALLATION
Important — read this first!
1 Inspect the bath before installation, to ensure there are no visible defects. If a defect is found, do not install the bath and
contact the supplier immediately. Claims for defects will not be accepted after the product has been installed.
2 The bath must be installed by a licensed tradesperson. Failure to do so may void the warranty.
3 Compliance with AS.3740 Waterproofing of Wet Areas within Residential Buildings applies when installing baths.
4 Local authorities may have specific installation requirements and this should be checked before installation.
5 Grade the bath sub-floor in accordance with requirements of local authorities. Grade sub-floor 1:60 minimum.
6 The protective film on the bath should be left intact during installation and should remain on the bath until first use.
Protective film | Care and maintenance of the bath surface
There is a protective film on the acrylic surface of the bath at the time of purchase. This should remain intact until the bath
1
is ready to use to protect the bath during installation.
2 To preserve its polished finish, this bath should be cleaned with a soft cloth using warm, soapy water or household
detergent. Do not use abrasive cleaning products.
3 If accidental scratches, abrasions or burns occur, the surface finish can be restored by gentle polishing with Brasso.
4 For full warranty terms and conditions, please visit seima.com.au
Base support for the bath
1 The design of acrylic baths allows the base of the bath to be supported by three timber support battens.
2 Position and fix timber support battens to the base of the bath and the floor, using a suitable floor and wall panelling
adhesive. Ensure that the bath is neatly fitted and properly supported.
3 During installation, use a spirit level to check that the bath rim is level.
s e i m a . c o m . a u
Ensure that the rim of the bath is level, using a spirit level.
timber support battens
Please note
−
All measurements are in millimetres.
−
Dimensions are nominal and subject to normal ceramic manufacturing variations of ±5mm.
−
Fixing: Use acetic cured silicone sealant. Do not use epoxy type adhesives.
−
Specifications may vary without notice as part of our continuous improvement practices.
−
Clean with a damp cloth. Do not use abrasive cleaners, liquids or pastes.
Please leave this guide
with the end user.
bath-select-tondo-in | v 2.0 | page 1 of 2