Stealth Cam DS4K Ultimate Instruction Manual page 14

DVR MODE: This setting allows you to continuously
record new images. Turning this setting ON will
continuously delete oldest recorded files to make
space for new files. When turned OFF, the camera
will stop recording new files when SD card reaches
capacity.
OPTIONS: On | Off
TEMPERATURE: This setting is used to change
temperature format on Info Bar.
OPTIONS: Fahrenheit | Celsius
LONGITUDE and LATITUDE: This setting allows
you to manually enter the longitude and latitude of
your camera.
OPERATING HOURS: This feature allows you to
designate a time for the camera to be active.
OPTIONS:
24/7: Camera is always on
SCHEDULED: Selecting this allows you to enter a
time range for the camera to be active. Camera will not
take photos outside of defined time range.
START TIME (HH:MM): Start time for camera to
be active
END TIME (HH:MM): Time at which you want the
camera to no longer be active
INFORMATION BAR: This setting is used to tell the
camera whether the Info Bar should be displayed at
the bottom of images.
OPTIONS: On | Off
VIDEO LENGTH: This setting is used to determine
the length of time, in seconds, of a video recording.
OPTIONS: 10 sec - 180 sec
Page 14
VIDEO AUDIO: This setting will determine if the
video records with or without audio. Recording audio
with each video will take additional memory space.
OPTIONS: Off | On
ERASE CARD: This setting is used to format the SD
memory card installed. Formatting your SD card will
ERASE ALL DATA PRESENT.
NOTE: After card is formatted it is impossible to
restore data that was present on card.
TIME LAPSE (TL) DELAY: This setting will adjust
the length of time between each photo taken during
the time lapse.
OPTIONS: 00 min 05 sec - 59 min 59 sec
TL START: This setting is used to determine the start
time of the time lapse.
TL STOP: This setting is used to determine the end
time of the time lapse.
SECURITY KEY: This setting allows the owner of the
camera to program a four (4) character alphanumeric
code to prevent unauthorized access to their camera
settings. Default code is 0000.
NOTE: The camera owner is responsible for remembering the
code. Should the code be forgotten the owner must call in to
Customer Service (877-269-8490) for directions on getting the
unit restored to factory defaults. In order for the owner to be
authorized for the reset, this camera must be registered with
Stealth Cam.