Table of Contents
Advertisement
3.) Install Lift Control Valve Fittings
a.) Install two ½" x JIC6 elbows into bottom ports on lift control valve. Tighten with wrench. Point
elbows as shown below.
b.) Install two pipe reducers and two ½" elbows into IN and OUT ports on lift control valve. Tighten
with wrench. Point elbows as shown below.
c.) Install conversion plug (saved from split control valve on previous page) into BYD port.
d.) Install handle onto lift control valve with long pin, short pin, and small cotter pins (cotter pins not
shown, they come in the same bag as the handle).
e.) Thread knob onto handle hand tight (the knob comes in the same bag as the handle).
Assembly
15
Advertisement
Table of Contents
