Condair Cube Quick Start Manual

Made in Switzerland
Thank you for purchasing the Condair Cube.
The Condair Cube uses a higly sensitive sensor to detect CO2, relative humidity (% RH) and temperature in
the ambient environment.
Before working with the measuring device, please read this Quick-Start Guide carefully!
– The Condair Cube is intended for indoor use only. Any other use is considered as non-intended use and
may cause the Condair Cube to display deviating measuring results. Any use not in accordance with the
intended purpose will void the warranty.
– By following the Quick-Start Guide, you will also avoid damaging the device and running the risk of your
legal rights to claim for defects due to misuse. We accept no liability for damage caused by non-observance
of this Quick-Start Guide.
– We are not liable for incorrect measured values and consequences that may result from misuse.
For your safety
– Do not use the product in any other way than described in these instructions.
– Unauthorized repair, modification or alteration of the device is not permitted.
Important notes on product safety
– Do not expose the device to extreme temperatures, humidity, vibrations and shocks. Clean the device with
a soft, slightly damp cloth. Do not use scouring agents or solvents!
PRODUCT OVERVIEW
Components: 1 measuring device and USB charging cable. Optional: Micro SD card (not supplied)
Button 1
Button 2
Display/Touchscreen
Housing
STARTING THE CONDAIR CUBE
1. Switch on the Condair Cube: To do this, press the power button inside the cavity on the lower, left
side of the cube (see product overview). Fully charge the device.
Note: If the Condair Cube is plugged in via the USB cable, it switches on automatically.
2. Place the Condair Cube upright in the room, where you want to check the room air, so that the sensor, on
the back of the Cube, is free from obstruction and the excess heat can escape through the ventilation slots.
QUICK-START GUIDE
Condair Cube
Air Quality Measuring Device:
– CO2
– Relative Humidity
– Temperature
Ventilation slots
LED (green)
Slot for Micro SD card
Sensor
USB charging cable port
Power button