Advertisement
Important Safety Information
Please read these instructions thoroughly and retain for future use.
All products supplied by Swan are safe provided they are installed, used correctly and receive regular maintenance in accordance with these
instructions. If you are in any doubt about your ability to install this product safely you must employ the services of an experienced qualified
plumber.
Remove all packaging and check the components for damage before starting installation. Before starting any installation please consider the
following:
Prior to drilling into walls, check that there are no hidden electrical wires, cables or water supply pipes. This can be checked with the aid of an
electronic detector.
If power tools are used do not forget to:
- Wear eye protection
- Unplug equipment after use
Specifications
Working Pressure Range:
Min 0.2 bar, Max 5.0 bar
Maximum Static Pressure:
10 bar
BS 6700 recommends the temperature of stored water
should never exceed 65°C. A stored water temperature
of 60°C is considered sufficient to meet all requirements
and will minimise the build up of limescale in hard water
areas.
Installation
This product needs to be installed in accordance with, and meet the
requirements of the Water Supply (Water Fittings) Regulations 1999
and current byelaws. For full Installation Requirements & Notes
(IRN) please visit www.wras.co.uk/directory.
Isolation valves must be fitted to the inlet water supplies to ensure
ease of future maintenance. Full access must be made available for
future maintenance/servicing purposes. Before installing this
product the water supply must be thoroughly flushed in order
to remove any swarf, solder etc.
This product must not be modified in any way as this will
invalidate the guarantee.
If in doubt, contact a registered plumber or your Local Water
Authority or the Secretary of the Institute of Plumbing,
address as follows:-
The Institute of Plumbing,
64 Station Lane,
Hornchurch,
Essex,
RM12 6NB, Tel: 01708 472791
Need help? Give us a call on 0330 0267 658 and speak to one of our trained advisors.
2
Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.
Tap Body
Washer
Fixing Nut
Installation Steps
1.
Identify all components before fitting.
- 1 x Tap Body
- 1 x Washer
- 1 x 'C' Shaped Fixing Kit
- Flexi Tails (Pair)
2.
Fit the mixer to the sink using the 'C' shaped fixing kit. The full
rubber washer goes between the tap and the basin. The 'C' shaped
rubber and metal washers on the underside of the basin.
3.
Fit the tail pipes to the tap body (hand tighten only) and connect the
hot and cold supplies.
4.
Fully open both valves, letting them run for a few minutes to flush
out the system. Check all joints and connections for leaks.
Fixing Rod
C Kit - Rubber Washer
C Kit - Metal Washer
Flexi Tails
Advertisement
