Advertisement
Timer cooking (continued)
11.
To alter the timer while it is counting
down simply press the Timer Button
12.
To cancel the timer, press and hold the
Timer Button
the Function Button
is active will cancel the timer and the
heating level will reset to 180˚C/1200W.
13.
The Hob can be turned OFF at any time
by pressing the Power Button
14.
When the timer is complete the hob will
beep and turn itself off.
15.
After the Heating Zone 2 has been
heated, the Cooling Fan 10 will operate
to cool the device. When the fan has
ceased operating it is safe to switch the
hob off at the mains and remove the
plug from the socket.
Lock Function
•
When the hob is in use, pressing the Lock
Button
will prevent all other buttons
from accepting input. The display will
cycle between the current temperature
and 'L'.
•
Pressing the Lock Button
unlocks the controls.
Cleaning after use
CAUTION: ALWAYS BE SURE THAT THE
INDUCTION HOB IS UNPLUGGED AND
COMPLETELY COOLED BEFORE CLEANING
OR ATTEMPTING TO STORE THE ITEM.
•
Hob Plate and Casing: Clean with a
cloth slightly dampened in a solution of
washing up liquid in hot water. Take care
not to get the outside of the appliance
too wet. Occasionally a proprietary Hob
Cleaner may be used on the Hob Plate
1 .
•
Air Circulation Ports: Wipe surfaces
with a cotton bud, or a cloth slightly
dampened in a solution of washing up
liquid in hot water.
DO NOT IMMERSE THE INDUCTION HOB
IN WATER OR ANY OTHER LIQUID.
for 3 seconds. Pressing
while a timer
.
again
Portable Induction Hob
DO NOT USE ANY ABRASIVE MATERIAL
TO CLEAN THE INDUCTION HOB,
OTHER THAN OCCASIONAL USE OF A
.
PROPRIETARY HOB CLEANER ON THE HOB
PLATE.
Error messages
If shown on the Display 3 , please report
these error messages to Judge Customer
Services at the address given in the Warranty
section:
•
E0: Cookware not present, is not suitable
for use with induction hobs or has an
induction base less than 12cm diameter;
hob powers off and "beeps" - use
compatible cookware.
•
E01: Induction cooker overheat
•
E02: Stove-top overheat
•
E03: Voltage underloaded/overloaded.
Cautions
•
Check that the electrical supply ratings of
the appliance are correct for your home
(see specification).
•
The induction hob must be fitted to an
earthed socket, which should have an
individually rated load of above 10A. The
plug must be fully pushed into the socket.
Overheating could occur if a socket is
shared and overloaded.
•
Do not insert plug with wet hands.
•
Do not operate this device using a timer/
controller, or remote control system.
•
Do not use outdoors.
•
Do not place the hob near a hot gas or
electric burner, or in a heated oven.
•
Do not use the hob in high humidity
conditions.
•
The hob should be placed on a level
stable worktop at least 10cm from walls
or other solid obstructions.
•
Do not use the induction hob on a metal
table.
Advertisement
