Advertisement
How to use
1.
Insert the Plug 9 into a mains socket
(check your supply is compatible with
the Rating Information) and switch on
at the socket. The Display 3 will briefly
illuminate.
2.
Press the Power Button
above the button will illuminate.
3.
Place suitable cookware on the Heating
Zone 2 in the centre of the Hob Plate
1 .
4.
Press the Function Button
light above the button will illuminate and
the hob will start to heat to 180˚C/1200W.
Please note the hob will beep
continuously and not activate if the
cookware is unsuitable.
5.
Press the Function Button
the Display 3 between Watts and
Temperature in ˚C.
6.
Change the Temperature to any of the 10
heating levels by pressing the
buttons.
1
2
3
6
7
8
Please note these temperature settings
are approximate and must be used as
a guide only. Temperatures can vary
+ or - 20° depending upon the type of
cookware used.
7.
The Hob can be turned OFF at any time by
pressing the Power Button
8.
After the Heating Zone 2 has been
heated, the Cooling Fan 10 will operate
to cool the device. When the fan has
ceased operating it is safe to switch the
hob off at the mains and remove the plug
from the socket.
, the light
once. The
to switch
and
4
5
9
10
.
Portable Induction Hob
Timer cooking
1.
Insert the Plug 9 into a mains socket
(check your supply is compatible with
the Rating Information) and switch on
at the socket. The Display 3 will briefly
illuminate.
2.
Press the Power Button
above the button will illuminate.
3.
Place suitable cookware on the Heating
Zone 2 in the centre of the Hob Plate
1 .
4.
Press the Function Button
light above the button will illuminate and
the hob will start to heat to 180˚C/1200W.
Please note the hob will beep
continuously and not activate if the
cookware is unsuitable.
5.
Press the Function Button
the Display 3 between Watts and
Temperature in ˚C.
6.
Change the Temperature to any of the 10
heating levels by pressing the
buttons.
7.
Press the Timer Button
above the T on the Display 3 will flash.
8.
Use the
and
desired length of time. The
goes up in blocks of 10 minutes, the
button goes down in single minutes. For
example, to set the timer to 35 minutes
press the
button 4 times (40 minutes)
and the
button 5 times (5 minutes).
Remember to allow enough liquid for
the length of time and temperature
being used.
9.
A couple of seconds after you have
finished setting your desired length of
time the light above the T on the Display
3 will stop flashing and the timer will
begin to count down. The Display 3
will alternate between the selected
temperature and the time remaining.
10.
The temperature can be adjusted while
the timer is running by pressing the
and
buttons.
, the light
once. The
to switch
and
. The light
buttons to set your
button
Advertisement
