Water Connection; Levelling; Electrical Connection; Transportation, E.g. When Moving House - Bosch WIS28440GB Installation And Assembly Instructions

Water connection

– Risk of electric shock. Do not immerse the Aqua-Stop s
(contains an electric valve).
– To prevent leaks or water damage, observe the inst
– Caution : only operate the washing machine using cold drinkin
– Do not connect to the mixer tap of an unpressurised hot-water boiler.
– Do not use a used inlet hose. Only use the inlet ho s e supplied or one which was
purchased from an authorised specialist retailer.
– If in doubt, have a technician connect the appliance.
Water inlet
Water inlet hose:
Caution : do not kink, squash, modify or cut through
(otherwise its strength is no longer guaranteed).
Optimum water pressure in the supply network: 100-1000 kPa (1-10 bar)
– Water flows at a rate of at least 8 l/min when the tap is turned on.
– If the water pressure is higher than this, a pressu
Water outlet
Water outlet hose:
Caution : do not kink or pull lengthways.
Height difference between the installation surface and the d rain:
– for Aqua
Drainage into a siphon:
Caution : the connection point must be secured with the hose cl amp
provided, Ø 24-40 mm.

Levelling

Intense noise, vibrations and "wandering" may be th
All four appliance feet must be firmly on the ground
The washing machine must not wobble.
Check the levelness of the washing machine with a spi rit level and adjust if necessary.
The washing machine must not rest against the side p anels of the installation recess.
The lock nuts of the front appliance feet must be scre wed tightly against the housing.
All manuals and user guides at all-guides.com
depending on model
afety device in water
ructions in this section.
g water.
re reducing valve must be installed.
Model: Aqua
max.
max.
90° 90°
3/4"
min.
10 mm
e result of incorrect levelling.
.

Electrical connection

The washing machine must only be connected to an al
installed earthed socket.
The mains voltage must correspond to the voltage sp
->Page 7; Technical data.
Connected load and required fuse -> Page 7; Technical data.
Make sure that:
– the mains plug fits the socket,
– the cable cross-section is adequate,
– the earthing system is properly installed.
The mains cable may only be replaced by a qualified electrician (if required).
Replacement mains cables are available from custome
Do not use multiple plugs/couplings and/or extensio n leads.
If a residual current circuit breaker is used, only
Only this symbol guarantees compliance with the cur
Mains plug:
– do not plug in to/pull out of the socket with damp hands.
– when removing the plug from the socket, pull the p
3/4"
– never pull the plug out during operation.
min.
10 mm

Transportation, e.g. when moving house

Before transporting the washing machine:
1.
1. Turn off the tap.
2. Reduce the water pressure in the inlet hose
4. Disconnect the washing machine from the power suppl
5. Disconnect the hoses.
Install the transport safety devices:
2.
1. Remove the
covers.
2. Insert all 4 sleeves.
Clamp the mains cable to the holders. Insert and
tighten the screws.
After transportation, the transport safety devices
To prevent unused detergent from flowing straight
Pour 1 litre of water into compartment II and start t
5
ternating current via a properly
ecifications on the washing machine.
r services.
use a type which displays this symbol: ‚ .
rently applicable regulations.
lug body only, not the cable.
−> Instruction manual; drain pump.
y.
must be removed.
into the drain during the next wash:
he Empty programme.
k
j
−> Page 4.
6