Advertisement
Mode Change Button
Bluetooth MAC
Address.
Bluetooth Antenna
Long press Mode Change Button for 6 second，The Bluetooth mode will change
from Mater to Slave and vice versa. If GS-D100BT work in Master mode, Scanner must work
in Slave mode for pair usage. If GS-D100BT work in Slave mode, Scanner must work in
Master mode .Normally, Scanner will work in Slave mode and GS-D100BT work in Master
mode. The GS-D100BT will beep one time after success mode change .
Long press Reset Clear Button for 6 second, GS-D100BT will clear memory for last
connected scanner. GS-D100BT will beep one time after successful reset, at same time, the
blue LED will blinking again .It indicate GS-D100BT is ready for pairing the new scanner.
At this time ,please use scanner scan the SPP mode barcode(Note:GS-D100BT only
support SPP Bluetooth transmission protocol)：
Tianjin Generalscan IOT Technology Co; LTD
Reset Clear Button
Advertisement
