Advertisement
Installation Steps
(Reverse operation when disassembling)
1. Install the vertical rod and feet
base.
Vertical rod
Vertical rod
4. Insert the corner connector into
the vertical poles on
both sides
Outdoor Use
Note:
If the outdoor wind power exceeds level 2,
this product cannot be used to avoid
personal injury or product damage!
Use a water bag when there is no wind; when
you use it outdoors, use a ropes to tie both
sides of the screen to adjust the position of
the bolt and the length of the ropes (as
shown in the picture).
Note: Stake cannot be used on hard ground.
2. Put screen sides of the screen
into the vertical pole.
5. Push the vertical rod to both
sides to make the screen
equal width up
and down.
Rope
Stake
3. Insert the upper transverse pole
and corner connector.
6. Fill the water bag with water
and press it on both sides of the
feet base.
Rope
Stake
Rope
Stake
www.PyleUSA.com
Rope
Stake
Advertisement
