Pioneer CP-VSL3 Installation And Usage Instructions page 8

6
Fasten the mounting fixture to the wall
When fastening the fixture to the wall, use a minimum of
six screw locations, including the four holes at the top and
bottom of the fixture (✱ marks). Mounting screws are not
furnished. Depending on the construction of the wall,
drywall anchors*
necessary; be sure to provide fully sufficient*
the speaker.
1
* Anchors should have minimum strength of
0.3kN (Newtons).
NOTE
2
* A safety factor of x4 or more should be
provided.
7
Install bushings
Install two bushings per speaker. The bushing is installed
so that the bushing's flange is separated slightly from the
fixture's surface; this helps prevent the speaker from
falling suddenly in the event the fixture should
accidentally become detached from the wall. Use drywall
anchors or other means to provide ample strength.
Bushing
8
En
1
or other reinforcements may be
2
<Cross section>
Wall
Bushing
Screw
Mounting
fixture
8
Attach safety strap to wall
Attach the safety strap to the wall. Using anchor bolts or
other means as necessary, provide ample support strength.
The strap is an important safety device to prevent the
speaker from falling, and should be installed in all cases.
support for
9
Connect speaker cords and pass through
mounting fixture
Connect the speaker cords and pass them through the
square hole on the bottom of the mounting fixture.
If you wish to pass speaker cords through the rear of the
mounting fixture, use either of the two holes on the bottom
of the fixture, then pass the cord through any of the three
round holes (φ 30) on the rear surface of the fixture, as
shown.
• When threading speaker cords from rear of speaker
10
Insert upper plate into mounting fixture
While passing the speaker's terminals through the square
hole in the fixture's bottom, set the speaker onto the
fixture, then place the upper plate onto the top of the
speaker as you insert the upper plate's tab into the
opening on the top of the fixture.
Safety strap
Use either of these
When accessing
speaker cords the
rear of the speakers,
use one of the three
round holes (φ 30) in
the rear surface of
the mounting fixture.
Opening