Changing your code
Open your Filex CR as normal
•
•
Remove the screw securing the black plastic plate with a small flat-headed screwdriver
•
You will need to turn the disk of each number in your previous code until the arrow faces
the NOT SET position
•
You can now repeat all of the steps in the section marked 'SETTING YOUR CODE' and
'CHECKING YOUR CODE'
Opening your key safe
•
Ensure that the dial is in the vertical position (shown in the
image below)
•
Enter your code
•
If you enter your code wrong, press and slide the clear button
down and then release the button. You can now re-type your
code
•
Rotate the dial clockwise 360 degrees, until it clicks
Pull the door open
•
Locking your key safe
•
Close the door and lock it by turning the dial anti-clockwise 360 degrees. It should click
at least once
Ensure that it has locked properly by turning the dial clockwise 360 degrees
•
•
until it clicks. Try and open the door, if it does not open your Keyguard XL is now fully
secure
Close the lid of the rubber cover
•
Trouble shooting
The dial must be in the vertical position to use the code buttons
•
•
If your code hasn't worked, ensure you press the 'CLEAR' button before entering the code
again
Ensure that the arrow on the dial of each button is in the SET position when setting your
•
code
•
Ensure that all numbers not in your code have their dials facing the NOT SET position
Ensure that the black plastic plate is properly and securely refastened
•
You may find that when you turn the dial you feel some resistance, do not worry, this is
•
normal.