Flex 1502000140 User Manual page 7

Filex CR key safe user manual (1502000140)
Opening the Filex CR key safe for the first time
Remove unit from the box and place it on its back
•
• Pull the rubber cover open
Make sure that the dial is in the vertical position
•
Press and slide the 'clear' button (the ridged black button
•
pictured below) down. Release the clear button.
• Turn the dial clockwise 360 degrees, until it clicks
Pull the door open
•
Setting your code
With the door open, turn the dial anticlockwise, until it clicks.
•
Make sure the locking bar is in the locked position
Stand the Filex CR upright, keeping the door open
•
Using a screwdriver, remove the central screw securing the
•
black plastic plate
• Choose a personal code which must be between 3 and 8
digits. NOTE: You may only use each number/letter once
• Using a flathead screwdriver, rotate each button in your code
180 degrees, so that the raised nib (the black dot in the
diagram) on each one faces the SET position.
Re-secure the black plastic plate with the small screw, make
•
sure you leave the door open to check your code
Checking your code
• With the door still open, make sure the Filex CR is locked by
rotating the dial anti-clockwise 360 degrees, until it clicks
Make sure the dial is in the vertical position
•
• Press and slide the clear button down and then release the
button
Use the keypad to input your chosen code
•
• Turn the dial clockwise until it clicks
• If it opens, the Filex CR is ready to use