Troubleshooting - Toro 51487 Operator's Manual

Note: Remove any old string remaining on the spool.
3. The spool will accept up to 15 feet (4.5 m) of string. Use
only .065 inch (1.6 mm) diameter monofilament string.
Note: Do not use any other gauge or type of string, as this
could damage the trimmer.
4. Insert the string into the anchor hole in the upper part of
the spool (Figure 20). Wind the string onto the spool in the
direction shown by the arrows on the spool.
5. Place the string in the slot on the upper spool flange, leaving
about 6 inches (152 mm) extended beyond the slot.
Note: Do not overfill. After winding the string, there should
be at least 1/4 inch (6 mm) between the wound string and
the outside edge of the spool.
6. Replace the spool and the spool retainer. Refer to Spool
Replacement earlier in this manual.
Battery Pack Preparation For
Recycling
WARNING
Upon removal, cover the battery pack's terminals with
heavy-duty adhesive tape. Do not attempt to destroy
or disassemble the battery pack or remove any of its
components. Lithium-ion batteries must be recycled or
disposed of properly at the nearest battery recycling
facility.
Service
Should this item need service, take the product to your Authorized
Toro Service Dealer. Your Toro Dealer is specially trained to repair
Toro products and will ensure that your Toro stays "All" Toro.
Storage
•
Clean all foreign material from the product.
•
Store it in a well-ventilated place that is inaccessible to
children.
•
Keep away from corrosive agents such as garden chemicals
and de-icing salts.

Troubleshooting

Using the battery when it is hot can reduce the operating time.
The battery will automatically stop working when it is overheated
to prevent damage to it. Remove the battery from the charger and
allow it to cool before placing it back into the trimmer.
Using the battery when there is moisture on the leads can cause
the trimmer to malfunction. Allow the battery to dry or wipe it dry
before placing it back into the trimmer.
Using the trimmer to cut thick grass in temperatures above 90
Fahrenheit (32 Celsius) may reduce the run time. Engage the
power saving feature to help increase the operating time. Refer to
Using the Power Saver Feature (page 11).
13