Advertisement
Cleaning & Care
1. ALWAYS turn off and unplug the appliance before cleaning!
2. Always allow the appliance to cool completely before cleaning.
3. Clean the filters regularly and whenever suction is not strong:
Dirt filter
a. Remove the dust bin and use the dust bin cover handle to lift out the
filter.
b. Turn the filter counterclockwise to release it.
c. Pull the filter out and tap it gently against a trash container to loosen
dirt.
d. Rinse the filter under running water until it's clean.
e. Let the filter air dry thoroughly before putting it back in place.
f. Never operate this vacuum without the dirt filter properly in place!
Micro-exhaust filter
a.. Slide the micro-exhaust filter holder up and out of the housing.
b. Gently pull the filter out of the filter holder.
c. Tap filter gently against a trash container to loosen dirt.
d. Wash the filter in mild soap and water. Rinse and air dry thoroughly .
before replacing.
e. Never operate this vacuum without the micro-exhaust filter properly in
place!
4. Wash the bin in warm water using a mild soap. Avoid harsh or abrasive
cleaners. Rinse thoroughly and air dry before putting the bin back in place.
5. Clean sensors, dirt inlet area and dust bin cavity with a damp cloth.
6. Wipe the exterior housing with a damp cloth.
7. DO NOT immerse any electrical appliance, cord or plug into water.
8. Ensure all parts are dried thoroughly before reassembling and using
this appliance.
8
wards.com
Troubleshooting
PROBLEM
POSSIBLE CAUSE
Vacuum won't run
1. Not firmly plugged in
2. Unit is off
3. Dirt filter is not in
position
4. No power in wall plug
.
Vacuum does not pick up
1. Dirt inlet is blocked
debris
2. Dust bin is full
3. Debris may be too
large for inlet
Sensors do not
1. Unit is not in AUTO
activate
mode
2. Debris pile is to small
to activate sensors
Suction is not strong
Filters may be dirty .
Power indicator light is
Vacuum has gone into
blinking
standby mode
Dust bin indicator Light
1. Dust bin is full
is on
2. Filters may be dirty
1
888
•
POSSIBLE SOLUTION
1. Plug in firmly
2. Turn control dial to
MAN or AUTO position
3. Check dirt filter
4. Check fuse or circuit
breaker
1. Clean path of dirt inlet
2. Empty dust bin
3. Clear large debris
1. Turn control dial to
AUTO
2. Turn control dial to
MAN and press manual
activation button
Clean filters
Turn control dial off and
then back on again
1. Empty the dust bin
2. Check filters
557
3848
•
•
9
Advertisement
